Debugger Kit de desarrollo ATATMEL-ICE-PCBA, JTAG, SWD, PDI, TPI, aWire, SPI, debugWIRE, UPDI para Microcontroladores

Ver tudo Programadores

Subtotal (1 unidade)*

58,15 €

Add to Basket
Selecione ou digite a quantidade
Em stock
  • 16 unidade(s) pronta(s) para enviar a partir de outro centro de distribuição
  • Mais 2 unidade(s) para enviar a partir do dia 29 de dezembro de 2025
Precisa de mais unidades? Insira a quantidade desejada e clique em "Verificar datas de entrega".
Unidad(es)
Por unidade
1 +58,15 €

*preço indicativo

Código RS:
130-6124
Referência do fabricante:
ATATMEL-ICE-PCBA
Fabricante:
Microchip
Seleciona um o mais atributos para encontrar produtos semelhantes.
Selecionar tudo

Marca

Microchip

Tipo de Accesorio

Kit de desarrollo

Para Usar Con

Microcontroladores SAM,AVR

Interfaz

JTAG, SWD, PDI, TPI, aWire, SPI, debugWIRE, UPDI

Nombre del programador

Atmel-ICE

ATATMEL-ICE PCBA


The Atmel-ICE series consists of development tools for debugging and programming ARM Cortex-M based Atmel SAM and Atmel AVR microcontrollers with on-chip debug capability. The Atmel-ICE series supports JTAG, SWD, PDI, TPI, aWire, SPI and debugWIRE interfaces and is compatible with Atmel Studio.

Kit Contains:


• Atmel-ICE unit without plastic encapsulation

130-6122 Full Kit available

130-6123 Basic Kit available

System Requirements


The Atmel-ICE unit requires that a front-end debugging environment Atmel Studio version 6.2 or later is installed on your computer. The Atmel-ICE should be connected to the host computer using the USB cable provided, or a certified Micro-USB cable.

How to turn the Atmel - ICE on?

The Atmel-ICE is powered by the USB bus voltage. It requires less than 100mA to operate, and can, therefore, be powered through a USB hub. The power LED will illuminate when the unit is plugged in. When not connected in an active programming or debugging session, the unit will enter low-power consumption mode to preserve your computer's battery. The Atmel-ICE cannot be powered down - it should be unplugged when not in use.

How does it connect?

The Atmel-ICE communicates primarily using a standard HID interface and does not require a special driver on the host computer. The Atmel-ICE must be connected to an available USB port on the host computer using the USB cable provided, or suitable USB certified micro cable. The Atmel-ICE contains a USB 2.0 compliant controller and can operate in both full-speed and high-speed modes. For best results, connect the Atmel-ICE directly to a USB 2.0 compliant high-speed hub on the host computer using the cable provided.

Tipo kit


Kit de cables: 177-9591
Kit adaptador: 177-9590
Kit básico: 130-6123
Kit PCBA: 130-6124
Kit completo: 130-6122

Links relacionados