The W5500 Ethernet Shield v1.0 can be used to provide your projects with internet connectivity.W5500 enables users to have the Internet connectivity in their applications just by using the single chip in which TCP/IP stack, 10/100 Ethernet MAC and PHY embedded. The shield also have two Grove connectors and a microSD card socket to support projects which require storing large amounts of data from Grove sensor. The RJ45 port (Where the Ethernet cable is connected to) is low enough to allow you to stack more shields on top of this one if needed.

Supports Hard wired TCP/IP Protocols : TCP, UDP, ICMP, IPv4, ARP, IGMP, PoE
Supports 8 independent sockets simultaneously
Supports Power down mode
Supports Wake on LAN over UDP
Supports High Speed Serial Peripheral Interface(SPI MODE 0, 3)
Internal 32Kbytes Memory for TX/RX Buffers
10BaseT/100BaseTX Ethernet PHY embedded
Supports Auto Negotiation (Full and half duplex, 10 and 100 based )
Not supports IP Fragmentation
3.3V operation with 5V I/O signal tolerance
LED outputs (Full/Half duplex, Link, Speed, Active)
Micro-SD card socket
Grove connector for I2C and UART

Selecionar tudo	Atributo	Valor
	Marca	Seeed Studio
	Nombre de producto	Placa Ethernet W5500
	Referencia del procesador	103030021
	Para Usar Con	Arduino

	Selecionar tudo
	Marca Seeed Studio
	Nombre de producto Placa Ethernet W5500
	Referencia del procesador 103030021
	Para Usar Con Arduino

Placa Ethernet W5500 Seeed Studio

Entrega GRÁTIS para pedidos superiores a 80,00 €

Links relacionados